u Heat is recovered from PH and/or AQC boilers on each cement plant line, and power is generated by a single steam turbine. u Heat is recovered from the raw material pre-heater exhaust gas by PH boilers. (The boiler inlet gas temperature is 300°C-350°C) Because the exhaust gas contains a large amount of dust, a dust remover is
2. Boiler circulator(s) must be rated for open loop applications. Do not use cast-iron circulators. 3. Boiler circulator(s) operate continuously. 4. The minimum pipe size for connecting to a water storage tank is 1 ½. 5. The minimum pipe size for connecting the boiler is 1 ½ for the Mod Con 300 VWH and 2 for the 500 and 850 models. 6.
application type diagram see installation manual for complete instructions. install in accordance with all local codes. typical piping for conventional single boiler installation lb-500, lb-750, lb-1000 • safety relief valve setting should not exceed pressure rating of any component in
TYPICAL PIPING FOR CONVENTIONAL SINGLE BOILER INSTALLATION
AQC & SP BOILERS. This product is the Waste Heat Boiler for Cement kiln head calcination cooler in the cement production line. This boiler (for short AQC boiler), along with the Waste Heat Boiler for kiln rear preheater in the cement production line (for short SP boiler) forms the waste heat recovery system.
Piping Layouts for Hydronic Heat | JLC Online
(boiler) and secondary (system) loops Closely spaced tees or a mixing manifold • Prevents flow in one circuit from interfering with another Example: As zone valves open, close, or modulate, and as system pumps vary speed, the boiler loop is not impacted. Monday, December 01, 2014 Modern Hydronic Designs For Condensing Boilers 7
Waste Heat Recovery Power Plant
Plumbing and Piping Plans Solution | ConceptDraw.com