FULTON PULSEHW SERIES INSTALLATION, OPERATION AND
The Fulton Endura+ hot water boiler is an automatic, fuel-fired, ultra high-efficiency boiler. The boiler can either have combustion air ducted directly from the outdoors or utilize conventional combustion air intake and flue methods. The boiler is capable of sidewall venting when the appropriate venting materials
Fulton Heating Solutions, Inc. -- PHW Manual -- 2010-0713 Page 10 Warning Operating the boiler beyond its design limits can damage the boiler, it can also be dangerous. Do not operate the boiler outside its limits. Do not try to upgrade the boiler performance by unapproved modifications. Unapproved modifications can cause injury and damage.
Introduction a) The Fulton Pulse combustion hydronic boiler is an automatic gas fired, direct vent boiler. This boiler utilizes pulse combustion principle. It requires no conventional burner controls, no pilot and no chimney. The combustion components are of integral design with the heat exchanger.
to the correct operation and mainte-nance of your Fulton Gas Fired Steam Boiler, and should be perma-nently available to the staff respon-sible for the operation of the gas fired boiler. These instructions must not be considered as a complete code of practice, nor should they replace existing codes or standards which may be applicable.
Instruction, Operation, and Maintenance Manual Boilers
The Fulton Pulse combustion hydronic boiler is an automatic gas red, direct jurisdictional/professional codes and vent boiler. This boiler utilizes pulse regulations. combustion principle.
Open all the valves in the feedwater line. Switch on the feedwater pump motor and fill the boiler, see Section 3 - Operation. The operation of the pump controls should be checked by using the boiler blowdown valve (located at the rear of the boiler). Open the boiler blowdown valve and slowly drain the boiler.
Gas Pulse Combustion Hydronic Heating Boiler (PHW)